Photo may contain optional equipment.
COMBO
Steel combination straight load bumper pull horse/stock trailer with feed mangers and tack compartment
Standard Features
Available Sizes
12' floor length w/2-3500# axles, 15" tires & 5-hole wheels
14' floor length w/2-3500# axles, 15" tires & 5-hole wheels
16' floor length w/2-5200# axles, 15" tires & 6-hole wheels
17' floor length w/2-5200# axles, 15" tires & 6-hole wheels
Dimensions
6'-6" body height
5' or 6' body width
28" tongue length
Undercarriage
Rubber torsion axles with four wheel independent suspension and greasable hubs for easy lubrication
Electric brakes on all wheels
Radial tires on silver modular wheels with chrome center caps
Spare tire rack only
Coupler & Jacks
2" coupler and safety chains with hooks (standard on 5' widths 12'-14' and 6' widths 12')
2-5/16" coupler and safety chains with hooks (standard on 5' widths 16' - 17' and 6' widths 14'-17')
Top-wind jack with caster wheel
Emergency breakaway system: switch, cable and battery box complete with battery and charger
Design Features & Hardware
Low profile 6" radius corner galvanneal roof
All steel frame with formed galvanneal panels
4' sides with 1" x 3" tubing above
Rubber mounted optical window in front
Solid side access door on curb side
Treated floor
Greasable exterior hinges
Aluminum tread plate gravel guard on front and fenders
Chrome trim with colored vinyl insert
Pin striping
Tag bracket
Front Tack Compartment Area
Tack compartment with feed manger above (saddle rack not standard)
Locking tack door with brush tray, blanket bar and recessed latch
Two bridle hooks in tack compartment
Load Area Equipment
Tubing divider in front stall with solid head and shoulder partition
Two feed doors with chrome circle vents and recessed latches
Solid center gate
Full swing half sliding rear gate
Four interior and four exterior tie rings
Butt chains in front stall with cover
Lights
DOT required lighting
CM Trailers reserves the right to make any change in paint, design, or construction as necessary for engineering. All visual representation, specification, and dimensions are based on the latest product information available at the time of publication. Some of the equipment shown or described is available at extra cost. At no time will any of the material or information contained in this publication have any justifications for resolving disputes. All axle ratings will be listed as per FMVSS 120, Section 5.1 states, the maximum load rating of the tires and rims fitted to an axle shall not be less than the GAWR specified on the certification label.
|
